News
GFCI Outlets vs Standard Outlets: Where NEC Requires Them and How to Wire (2026)
GFCI outlets (Ground Fault Circuit Interrupters) are one of the most important safety devices in modern electrical s...
Read more
MC4 Solar Connector Compatibility Guide: NEC 2020, UL 6703, and Intermateability (2026)
MC4 connectors are the universal standard for photovoltaic systems, but not all MC4s are created equal. Intermateabi...
Read more
Lever Wire Connectors vs Wire Nuts: Which Should Electricians Use? (2026)
Wire nuts have been the default splice method since the 1960s, but lever connectors are gaining fast. Are they worth...
Read more
Compression Lug Crimping Guide: Tools, Dies & Techniques (2026)
A properly crimped compression lug creates a gas-tight, cold-welded connection as conductive as the wire itself. An ...
Read more
EMT vs Rigid vs IMC Conduit: Complete Comparison for Electricians (2026)
EMT, rigid (RMC), and IMC each have distinct strengths and NEC requirements. This guide covers when to use each base...
Read more
Cat6 vs Cat6a vs Cat7: Which Ethernet Cable Do You Need? (2026 Guide)
Choosing between Cat6, Cat6a, and Cat7 is one of the most common questions from IT managers, contractors, and homeow...
Read more
The Complete Engineering Guide to Compression Lugs: Technical Specifications, Applications & Performance Analysis (2026)
The comprehensive technical resource for electrical engineers specifying compression lug connections in mission-criti...
Read more
Why Solar Contractors Are Switching to Direct Component Sourcing (Saving $3,000+ Per Install)
The solar installation industry is brutal. Margins are thin, competition is fierce, and one bad component failure can...
Read more
EMT Fittings Buying Guide: 7 Costly Mistakes That Kill Project Profits
EMT conduit fittings seem straightforward until they're not. One wrong specification, cheap component, or sizing erro...
Read more
5 Signs You Need Higher-Performance Compression Lugs
When electrical contractors cut corners on compression lugs, it shows up in callbacks, project delays, and frustrated...
Read more
The Ultimate Guide to Battery Lugs: Tinned vs. Non-Tinned Copper
Why Conversions Tech Lugs Are the Industry Standard
Read more
NEC Compliance for Rigid Conduit Bodies
Rigid conduit bodies are regulated by the National Electrical Code (NEC) under Article 314, which governs outlet, device, pull, and junction boxes. Conduit bodies fall under this category because they provide access for conductor pulling, splicing, and maintenance. To ensure installations remain safe and code-compliant, the following NEC requirements must be observed:
Read more
