RV / Marine Accent Lighting

Every strip and puck ships pre-terminated with crimped, tinned-copper leads and color-matched VHB pads, so you can peel-stick-wire in minutes—no soldering, heat-shrinking or guessing polarity. That trims average install time by 40 %.
Competitors often ship bare wire ends that must be tinned on-site.

Yes. Puck lights come with #8 stainless screws and a reusable ¾″ hole-saw template, while LED strips include alcohol wipes, adhesion promoter, and wire retention clips. Lumitec’s courtesy lights typically ship hardware-free. :contentReference[oaicite:0]{index=0}

IP-68 means Conversions Tech fixtures survive continuous immersion—ideal for bilges, pontoon undersides, and exterior toy-hauler ramps—whereas Lumitec’s Exuma lights are IP-67 (splash-proof, not submersible). :contentReference[oaicite:1]{index=1}

Our optional QC-Harness uses sealed Deutsch DT plugs every 1 m, letting techs daisy-chain up to 45 ft of strip without butt-splices—perfect for production-line RV or yacht builders.

Absolutely—our buck-boost driver accepts 9 - 32 V DC, keeping brightness rock-steady even on lithium banks charging at 29 V.

Just a wire-stripper, ¾″ hole-saw (included template), and a #2 Phillips. No crimp sleeves or epoxy potting required.

Yes—each driver has reverse-diode protection and MCU-controlled thermal throttling so LEDs dim, not die, in overheated lockers.

A reusable PVC template is taped to every six-pack—great for dealers cranking through multiple conversions in a day.

No—constant-current regulation keeps lumen variance < 1 %, so lights stay uniform from AGM float to alternator charge.

Phone and chat support run 8 a.m.–6 p.m. MST out of our Wyoming HQ—no outsourced scripts, just marine-savvy techs.

Yes. We certify to the newly accepted 2025 ABYC C-5 LED navigation standard—the same rule set the USCG just green-lit. :contentReference[oaicite:2]{index=2}

• RV & motorhome manufacturing
• Boat/yacht builders & refit yards
• Van-life upfitters
• Food-truck & concession-trailer fabricators
• Emergency-vehicle upfitters (fire, EMS)
• Glamping & eco-resort operators
• Tiny-home and off-grid cabin builders

Pre-sealed drivers and vibration-resistant PCB potting virtually eliminate loose-lamp failures—common on pothole-shaken travel trailers.

Higher lumen-per-watt, tinned leads, and cut-to-length harnesses mean fewer callbacks and happier #VanLife influencers.

No need to add heat-shrink or resin at terminations—saving up to 20 min per strip inside damp lazarettes.

Yes—polycarbonate lenses are NSF-friendly and resist grease vapors better than acrylic domes.

Definitely—the IP-68 seal, wide-input driver and red/blue RGBW modes make them perfect for ambulances and rescue rigs.

Most tiny homes run 24 V solar banks—our 9-32 V input means a direct tie-in without step-down losses.

The PU encapsulant resists ammonia, urea and road salt—ideal for farm equipment and de-icing trucks.

Warm-white under-deck strips and RGB camp-logo uplights create IG-worthy vibes that drive five-star feedback.

A 12″ CT strip outputs ~1,800 lm versus Kohree’s 1500 lm 16.7″ ceiling fixture—20 % more light in 30 % less space. :contentReference[oaicite:3]{index=3}

Slim-Fit pucks are 0.30″ deep; Acegoo’s slim model measures 0.35–0.50″. :contentReference[oaicite:4]{index=4}

Conversions Tech already offers a 5-year “no-quibble” warranty with no registration, while Lumitec’s new 5-year plan still requires an online RMA. :contentReference[oaicite:5]{index=5}

Yes—Lumitec Spectrum lights require a Poco or third-party TTP controller; Conversions Tech embeds RGBW logic on-board. :contentReference[oaicite:6]{index=6}

Many low-cost lights include bare copper leads that corrode quickly; CT ships marine-grade tinned-copper conductors out of the box. :contentReference[oaicite:7]{index=7}

Up to 140 lm/W—roughly 20 % higher than average marine LED strip efficiency.

Orders placed before 2 p.m. MST ship same-day from Cheyenne, Wyoming; continental U.S. transit averages 2-3 days via UPS Ground.

No—the driver is FCC Part 15B compliant (< 30 dBμV/m) and fully shielded.

An optional BLE module (sold separately) lets you run presets and color fades via iOS/Android.

Yes—our nav fixtures are already built and tested to the now-accepted ABYC C-5 spec, ensuring compliance as rules tighten. :contentReference[oaicite:8]{index=8}